Полигон-2

Schicchi написал:

[q]

Согласно информации из последней ссылки - такая конфигурация должна работать.

[/q]

Извини, не увидел сообщения об успехе этой операции в упомянутой теме. Развод "по углам" параллельного и встроенного флопоконтроллеров там упомянут, но из комбо-флопа, типа SD-700 от эпсона, автор видит только трёхдюймовку, устанавливая её тип в драйвере backPack-а....

http://www.minuszerodegrees.ne...driver.htm
http://www.minuszerodegrees.ne...tup_cd.htm

http://www.vcfed.org/forum/sho...tion/page3

[q]

There are at least 4 versions of this drive. The latest take a 5VDC power supply; earlier ones take a 9VAC; still earlier ones take something like 13.8VAC. To be 100% sure, you have to look at the innards, if you can't find any voltage rating on the outside.

Opening one of these things is a little tricky. But fear not, there are some ways around the problem.

If it's an all-metal-cased unit with a permanently attached cable, either a 13.8VAC or 9VAC power supply will work, if it's a 3½" unit. If it's a 5¼" drive, you need the 13.8VAC supply.
If it's a plastic-housed 3½" drive, look at the back plate, near the power switch and power connector. If, slightly above and to the left of the power connector, there's a screw head, you need a 9VAC power supply.
If, instead you see a hole in the aluminum plate, not filled with a screw, you need to use a 5VDC power supply.


As far as the ratings, if you've got a 5¼" unit, you should have at least a 1200 mA supply current. The 3½" units will work fine with 800 mA. The 5VDC supply is 1600mA with center pin positive/shell negative.

[/q]